Instructions for Pavilion Codelocks

Instructions

To open: Press “C” followed by the access code.

For code-free entry: Press “C” followed by the access code and then press “Y” before opening the door. The door will remain unlocked until “Y” is pressed again.

To cancel code-free entry mode, press “Y” followed by “C”

Changing the code

Press the 'Y' button and the 'C' button to ensure that the lock is not in passage set mode and, when changing code, do not reposition 'Y' or 'C' tumbler.

1. Take your CL400 lock off the door by unscrewing the 2 bolts in the backplate.

2. Press the C button to reset the chamber and place the lock case on a flat surface with the buttons down.

3. Remove the 2 red screws and carefully lift off the code chamber plate. Check that all 14 springs are held in place on the plate.

4. Note that the red tipped code tumblers correspond in position to the existing code The blue tipped non-code tumblers fill the other positions. The C tumbler is not coloured.

5. Hold the lock in your hand and depress the C button. Keeping the C button depressed use tweezers to re-position the tumblers to correspond with your new code. The square notches of ALL tumblers MUST face outwards, with the coloured tips ON TOP. DO NOT force the tumblers in.

NB: Holding the C button depressed whilst removing or replacing the tumblers is ESSENTIAL to avoid damaging the internal mechanism. DO NOT attempt to reposition the C tumbler.

6. Replace the code chamber plate carefully with the 2 red screws.

7. Check the operation of the new code, and make a written note of it before re-installing the lock.

8. Note: Fit either the BLUE or RED tipped spindle to the code side dependant on hand of door.

9. Fit the butterfly spindle to the inside, non-coded side.

www.codelocks.com